SAFETY FIRST SAFETY INSTRUCTIONS These safety instructions provide information necessary for safe operation of pneumatic tools. DO NOT attempt to operate the tool until you read and understand all safety precautions and manual instructions. Always wear hearing and eye protection devices, including side shields when operating or working in the vicinity of a tool. WEAR EYE AND HEARING PROTECTION THE TOOL MUST BE USED ONLY FOR THE PURPOSE FOR WHICH IT WAS DESIGNED Do not throw the tool on the floor; strike the housing in any way or the tool as a hammer to knock material into place. The tool is not a toy so do not use it like one. Never engage in horseplay with the tool or point it at yourself or any person, even if you think it is not loaded. NEVER ENGAGE IN HORSEPLAY WITH THE TOOL Check the magazine for fasteners that may be left in the tool. Even if you think the tool is empty or disconnected never point it at anyone or yourself. Unseen fasteners could fire the tool. NEVER ASSUME THE TOOL IS EMPTY NEVER CLAMP THE TRIGGER IN A LOCKED OR OPERATING POSITION The trigger of the tool must never be tampered with; disabled or clamped in a locked or operating position since this will cause the tool to driver a fastener any time the work contacting element is depressed. DO NOT LOAD FASETNERS WITH THE AIR LINE CONNECTED, OR WITH THE TOOL TRIGGER OR WORK CONTACTING ELEMENT DEPRESSED When loading fasteners into the tool, make sure to disconnect the air line and not to depress the trigger or work contacting element. -3-
Download PDF file
Archive