6 Handed / Non-handed insert designs available depending on application (DCMX…/TPMX…) Non-handed insert design Non-handed insert for general purpose Handed insert (Drawing shows left-hand) Easy use similar to non-wiper inserts Wiper (both sides) Proper use of non-handed and handed inserts Non-handed insert design rε (Corner-R) Wiper (Only one side) Handed insert design Programming correction necessary R Programming correction Less corner-R accuracy necessary Programming correction necessary Using non-handed wiper insert · Programming correction necessary at 3 points · For machining with less Corner-R accuracy required Caution (Finished edge line) Non-handed insert design Facing R Ramping Boring R Up facing R Accurate corner-R Programming correction necessary Using handed wiper insert · Programming correction only necessary for plunging · Accurate corner-R available Similar use as a non-wiper insert with fewer programming corrections * C utting-edge position is different with non-wiper insert Please adjust cutting-edge position Application Boring/Facing Up facing/Ramping Caution For D type and T type inserts, expected performance may vary depending on toolholders Please check the applicable toolholder For D type and T type inserts, Z-direction program corrections are required R/ R Wiper Insert should not be used when an accurate Corner-R is required Radius cutting (Differences from non-wiper insert) Cut-off and cut-away will occur between radius machining and straight machining There is a limit to the use of a wiper insert when there is an R parameter symbol Please refer to the list on the right for finished dimensions There is no limit for using CCMT type inserts CCMT type inserts meet ISO standard Cut-O Wiper insert No wiper Cut-Away D type, T type Nominal corner R 0.2 0.4 0.8 Unit: mm Finished dimension R0.2 +0.3 −0.1 R0.4 +− 0.2 R0.8 −+ 0.5 Handed insert design Facing R Ramping Boring R Up facing Application Boring Ramping R/ R Up facing Facing Caution For D type and TP type inserts, expected performance may vary depending on toolholders Please check the applicable toolholder For D type and TP type inserts, Z-direction program corrections are required Same as non-wiper insert Same as non-wiper insert Same as non-wiper insert 3
Download PDF file
Archive