English 10 mm to 20 mm grade 60 (420MPa) re-bar (reinforcing bars), up to 13 mm I.D pipe, 20 mm O.D. copper water pipe, 20 mm O.D. tubing, 13 mm conduit, 20 mm square steel tubing & bar, and up to 20 mm O.D. all-threaded or coil rod. Rules of Use and Storage - To use the tool to its fullest performance, the user is required to be fully familiar with the saw itself, the cutting blades, and storage procedures upon completion of work. Specification The power tool is a multipurpose saw with an enclosed guard and flush cutting capabilities. The specifications of the main unit are as follows. Standard Blade: (Best for Ferrous Metals) Supplied with (2) each 110 mm Blade diameter × 1.6 mm thickness, 24 teeth with laser welded flange for mounting to TJEP RC20 ROD Cutter spindle. The maximum blade RPM is 2000. Operation Checking and Preparation of Working Environment: Check the following before using the TJEP RC20 Rod Cutter. Always observe the instructions and prohibited items. Checking of weather conditions, do not use in the rain or snow: !DANGER: TJEP RC20 Rod Cutter is not a waterproof power tool. If it becomes wet, the power source system may become faulty or the operator may get an electric shock. Therefore, when it is raining or snowing, never operate this saw outdoors, on top of buildings or under roofs where rain or snow enters freely. Do not use where water accumulates or where water splashes. Operation Instructions Adjust the rear handle position to comfortably grip the tool. (The rear handle changes position with the button located on the top of the handle.) Locate the front handle in the mounting hole that provides the best grip. To operate the trigger, depress the trigger lock button (on the side of the tool) and then pull the trigger to start the saw. Start the saw before cutting and then apply a light pressure moving forward through the cut. !DANGER: Electric Shock Hazard. Ignoring this warning may lead to death or serious injury. When raining or snowing, do not operate outdoors or indoors where rain or snow enters freely or in extreme temperatures. Do not use under high temperature and humidity or extremely cold temperature conditions. The tool is designed for use under an allowable environmental temperature of 0 to 38°C.Operation at higher temperature may cause the tool’s main unit to overheat. Operation at high temperature with high humidity may cause the tool to fail due to condensation. 15
Download PDF file
Archive